Recent content by rgroh

I just got this unit and I replaced the internal battery, I don't have the manuel but I'm trying to figure out how to set it up? It doesn't recall anything, does this unit have pre settings? and if so how do I get it to work? programming?? Don't have the card. Any help will be appreciated, Russ

Is it possible to send 8 tracks from my tascam 488 to the digital 788? If so what would be the best way to do it? Thanks, Russ

I hope this doesn't sound like a stupid question but I have a 70's silver face twin reverb and I want to replace the 7025 tubes, but all I find are 12AX7's, is this the same tube as I'm lead to believe? And why does the tube chart call out for two 7025's when it also calls for two 12AX7's?? any...

Well I did get the 788 and now trying to figure out how to bounce tracks 1,2,3,4 to track 5 mono, but no luck so far. I was able to record 1,2,3,4 to 7/8 stereo. Any help will be appreciated. Russ

Hi, I'm confused on what to invest in, I'm thinking about getting the tascam 788 for $900 or should I just get another computer and install gina or layla soundcard or similiar?? I have a studio but it's in my basement and the wife and kids use this computer so that's one reason why I'm asking. I...

I just got a marshall micro stack with 2 10inch bottoms, both cabs are 16 ohms each, if I hooked up a 12 inch 8 ohm bottom with one of the 10 inch 16 ohm speaker what would the total ohms be??? I can't go any lower than 8 ohms total. Any help would be appreciated. Russ

Hi, I just put some tunes up at this address: http://www.mp3.com/12ouncecurl Give a listen and let me know what ya think. Thanks!

Is it possible to take my tascam 488 8 tracks and record each track separately to this software and have it play back together? Russ

I'm recording with a tascam 488 8 track and mixing down to my computer using sound foundry XP4.5, I would like to update my studio with a digital recorder that I can mixdown 8 tracks with 8 outputs and drop them to Vegas Pro software, what is one of the better unit available to do the job and...

My drummer is thinking about getting one of these units and putting trigger pads on his acoustic drums for recording, my question is would you get alot of bleeding when you used mics for the cymbals and overall does anyone have any opinions on the D5 with recording?? Thanks, Russ

I'm having trouble with noises when I'm going from my dvd to cdr, I'm getting some crackling and pops near the last 3 to4 song on the cd. The wave file sound fine and the master cd I made from the wave files also sound fine. I'm using HP pavilion computer 8566C that has dvd and cd writer plus...

I was using a Sony pair of headphones MDR V202 for the pass year and now I using AKG K240 and the volume is alot lower thru the 488 compared to the sony pair, but it sounds alot better, is this normal? and how can I increase the volume with the AKG's, I'm all the way up on my 488. Thanks russ

Does anyone know where your levels should be on the level ruler when you are making a wave file? Having difficulty converting to working with the computer after years of analog recordings and knowing where the levels should with tape but I have NO idea where levels should be when recording...

I just got the Sound forge XP and wanted to know if it's possible to add effects to a wav file while it's playing, cause right now all I can do is add effects only when the file stops and than I have to restart it to see how it sounds, it would be alot easier to do it while it's playing. Any...

Well I finally getting into mixing down to digital with my new HP pavilion computer which has adatec soundcard + riptide mixer. I was able to take my tascam 488 tracks and drop it to a wav file and than was able to burn a cd, but I would like to get a software that will give me more control with...